D. Customizing the Graph (Continued)

Adding Condition/Phase Change Lines (Continued)

1. Place the cursor on the graph where you would like to start the line.  The line is placed between the last data point of the previous condition, and the first data point of the next condition.
2. Press and hold down the mouse button while holding down the shift key.
3. Drag the cursor to the point where you would like the line to end.
4. Release the mouse button then the shift key.
5. To move the line, place the cursor in the middle of the line, click and hold the mouse button, and drag.

Previous                              Next                              Return to Table of Contents

---

© Special Education & Rehabilitation Department - Utah State University